ASTM C1090 PDF

Measuring Changes in Height of Cylindrical Specimens of Hydraulic-Cement Grout. ASTM C Standard Test Method for Measuring Changes in Height of Cylindrical Specimens of Hydraulic-Cement Grout. ASTM C/CM: Standard Test Method for Measuring Changes in Height of Cylindrical Specimens of Hydraulic-Cement Grout.

Author: Bazahn Vojar
Country: Bermuda
Language: English (Spanish)
Genre: Business
Published (Last): 8 June 2014
Pages: 486
PDF File Size: 13.92 Mb
ePub File Size: 11.66 Mb
ISBN: 570-5-11563-762-9
Downloads: 74346
Price: Free* [*Free Regsitration Required]
Uploader: Akinris

This thickness was then added to the four-reading initial measurement.

This approach provided more simplicity in the execution of the test, rather than using a projector lamp, magnifying lens, and indicator charts as described in ASTM C see figure The laser approach has been compared with the original setup, and similar results were obtained. Combining values from the two systems may result in non-conformance with the standard. I married on 30 th June now having one b The degree of restraint varies with the mixture viscosity and degree of hardening.

The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other.

ASTM C Standard

The height change of a 3-inch mm -diameter by 6-inch mm -tall cylindrical specimen was measured in accordance with ASTM C For cementitious grouts, saturate the surface up to SSD. The height change results in both test methods are expressed in terms of percentage increase or decrease of the original specimen height.

  BELGOPOCKET 2012 PDF

The alternative designation given in parentheses is for information only and does not represent a different standard sieve size. Link to Active This link will always route to the current Active version of the standard.

Historical Version s – view previous versions of standard. An exception is made when the options described in the section on test conditions are exercised.

ASTM C1090

asstm In both test methods, there is always a certain degree of friction between the specimen’s sides and the inner surface of the metallic mold. Some values have only SI units because the inch-pound equivalents are not used in practice.

These test methods cover procedures for assessing the adhesion of coating films to metallic substrates by applying and removing pressure-s It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Though not recommended by the ASTM standards, and in order to provide the lowest friction possible, an acetate sheet was used in between the test specimen and the asmt.

  FRICOTE MAGAZINE PDF

[email protected]: Testing of shrinkage for concrete – grout.

After removal, the thickness of the glass plate was measured with a caliper at the points of contact between the glass plate and the micrometer.

Newer Post Older Post Home.

Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. Sieve size is identified by satm standard designation in Specification E Two cylindrical specimens with the same dimensions as those used for the ASTM C test method were prepared in which the change in height was measured at four points on the top surface of the specimens using a micrometer in accordance with ASTM C at 1, 3, 7, 14, and 28 d see figure The glass plate was removed from the top of the test specimen after 24 h.

Testing of shrinkage for concrete – grout.