ASTM D Standard Test Methods for In-Place Density and Water Content of Soil and Soil-Aggregate by Nuclear Methods (Shallow Depth). depth, etc.) Verify proper rebar sizes and placements. Verify proper reinforcing overlaps. Verify proper clearance and that chairs are. ASTM D Uploaded by Xavior. Standard Test Method for In-Place Density and Water Content of Soil and Soil- Aggregate by Nuclear Methods (Shallow.

Author: Vit Tulkree
Country: Belarus
Language: English (Spanish)
Genre: Marketing
Published (Last): 19 March 2015
Pages: 290
PDF File Size: 10.64 Mb
ePub File Size: 13.3 Mb
ISBN: 239-8-27121-243-4
Downloads: 30073
Price: Free* [*Free Regsitration Required]
Uploader: Gataxe

Active Risk Management

Measurements for water moisture content are taken at the surface in backscatter mode regardless of the mode being used for density. Reliable results depend on many factors; Practice D provides a means of evaluating some of those factors. The water mass per unit volume is determined by the thermalizing or slowing of asrm neutrons by hydrogen, a component of water.

In addition, they are representative of the significant digits that should generally be retained.

ASTM D6938

The quality of the result produced by this standard zstm method is dependent on the competence of the personnel performing it, and the suitability of the equipment and facilities used. Referenced Documents purchase separately The documents listed below are referenced within d66938 subject standard but are not provided as part of the standard. Soil testing Back to Results Print. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.


Most gauges display this value directly.

ASTM D Standard

Historical Version s – view previous versions of standard. Measurements for water moisture content are taken at the surface in backscatter mode regardless of the mode being used for density.

Link to Active This link will always route to the current Active version of the standard. Users of this standard are cautioned that compliance with Practice D does not in itself ensure reliable results. The total or wet density of soil and soil-aggregate is measured by the attenuation of gamma radiation asrm, in direct transmission, the source is placed at a known depth up to mm 12 in. For more information, contact: It is beyond the scope of this standard to consider significant digits used in analysis methods for engineering design.

This test method describes the procedures for measuring in-place density and moisture of soil and soil-aggregate by use of nuclear equipment.

For Individuals with needing special assistance for disabilities or limited English proficiency Please contact our Title VI specialist at The asmt source and the thermal neutron detector are both located at the surface of the material being tested. Soil testing Field Services: The water content most prevalent in engineering and construction activities is known as the gravimetric water content, w, and is the ratio of the mass of the water d698 pore spaces to the total mass of solids, expressed as a percentage.

  BGV A8 DIN 4844 PDF

The nondestructive nature allows repetitive measurements at a single test location and statistical analysis of the results.

When divided by the density of water and then multiplied bye6938 water mass per unit volume is equivalent to the volumetric water content. The direct transmission is the preferred method.

Request Quote Client Login. Most gauges display this value directly. The density of the test sample in mass per unit volume is calculated by comparing the detected rate of gamma radiation with previously established calibration data.

This places the gamma and neutron sources and the detectors in the same plane. The values in inch-pound units ft — lb units are provided for information only. The dry density of the test sample is obtained by subtracting the water mass per unit volume from the test sample wet density Section